Sempell Model 142 High Pressure Water Control Valve

Sempell Model 142 High Pressure Water Control Valve

Specially designed low-maintenance control valves for a wide range of applications in water circulation.
Sempell™ series 142 designer angular water control valves for the following applications:
• Water injection at HP/IP Bypass.
• Feedwater Start-up Control valve.
• Minimum Flow valve at Feedwater pumps.
• Blow-down valve at drum boilers.
The narrowly scaled Cv values-series and a large control ratio allow an exact adjustment for the respective task. The trims can be easily changed. A huge combination of material choices and multi pressure reduction stages.

Any questions?

Anders Praem
Inside Sales Engineer
Phone. +45 2137 7759

Anders.Praem@askalon.dk

Frank Kirk Hansen
Area Account Manager West
Phone. +45 4053 6511

Frank.Kirk@askalon.dk

Slawka Pedersen
Inside Sales Manager
Phone. +45 2137 7702

Slawka.Pedersen@askalon.dk

Joonas Jägerroos
Service Technician
Mob. +358 40 610 4439

Joonas.Jagerroos@askalon.fi

Size DN 65 to DN 400 / NPS 1 to 10
Pressure class Class 3000
Pressure Up to 480 bar, Up to Class 2800
Temperature -29 °C to 400 °C, -20 °F to 750 °F
Body material A105, A182 F12 / A182 F22 special design 
Trim material Stem 1.4057 / 1.4122 (17% Cr steel)
Cages 1.4057 / 1.4122 (17% Cr steel)
Seat ring 1.4057 / 1.4122 (17% Cr steel)
Stem sealing PTFE (up to 480°F), pure graphite
Plug design A–type – parabolic Flow To Close (FTC)
L–type – multistage Flow To Close (FTC)
X–type – single stage Flow To Open (FTO)
Characteristic Equal percent (square, linear on request)
Control ratio Standard 1:40
Sealing seat/plug Metallic
Connection Butt weld ends acc. to ASME B16.25 or ISO 9692-1
Leakage class ANSI / FCI 70–2 class V DIN EN 12266–2 class B
  • Modular design.
  • The valve is suitable for continuous operation.
  • Good adjustment to the task by narrowly staged Cv–value–series and large control ratio.
  • Trims can be changed easily while valve is welded into pipe.
  • Different plug types available.
  • Minimized wear and tear through separation of sealing and control area at high Δp.
  • Different actuator types can be used.
  • With low–friction PTFE packing at design temperatures ≤ 480°F.
  • Resistant for standard pickling process.
  • The stem nut can be re–lubricated during operation.
  • Thermal expansion by high temperature differences at stem will be balanced by cup spring in yoke head.

Questions about the product?

Fill out the form below and we will contact you with answers to your questions