Fisher C1 pneumatisk regulator

Fisher C1 pneumatisk regulator

Fisher™ C1 styrenheter och sändare fortsätter traditionen med hållbar och pålitlig Fisher-tryckinstrumentering, samtidigt som man tar itu med luft/gasförbrukning. C1 används när varaktigt och pålitligt tryckinstrument krävs.

Har du några frågor?

Jörgen Sundin
Solution Seller
Tel. 054-57 92 12

Certifications ATEX, CUTR
Input Signal Pneumatic
Max Outlet Pressure 40 psig
Mounting Type Remote Mount, Actuator Mount
Operating Temperature Standard Temperature
Position Control On/Off, Modulating Control
Process Control Pressure
Supply Media Air, Natural Gas
  • A Bourdon tube is available for high pressures or bellows for vacuum and low pressures. Either kind of sensing element can be installed in the case with the controller or transmitter. Two interchangeable ranges of output bellows and gauges also are available.
  • The C1 pneumatic controller is an energy efficient choice, helping to improve profits and uptime. Steady-state consumption rate is less than the 6 scfh requirement set for the oil and gas industry by the US Environmental Protection Agency.
  • Materials are available for applications handling sour process fluids. These constructions comply with the metallurgical requirements of NACE MR0175 / ISO15156 and NACE MR0103.
  • Install the case on a panel, wall, pipestand, or directly on the control valve actuator.
  • A spring-out cleaning wire provides for in-service cleaning of the relay orifice.
  • The C1 controller can be configured to provide various modes of control.

Frågor på produkten?

Fyll i formuläret nedan så kontaktar vi dig och svarar på dina frågor